- Services & Support
- Sales & Distribution
Directional Valves — HyPerformance
HCV12-20 — Check Valve, High Pressure
Selection guide - similar valves.|
PDF file of this page
Request a quote
A screw-in, cartridge-style, hydraulic check valve for use as a blocking or load-holding device.
The HCV12-20 allows flow passage from 1 to 2, while normally blocking oil flow in the opposite
direction. The cartridge has a fully guided check which is spring-biased closed until sufficient pressure
is applied at 1 to open to 2.
• Hardened seat for long life and low leakage.
• Optional bias springs for back-pressure application flexibility.
• Fully guided check assembly.
• Cost-effective cavity.
• All HyPerformance products are tested to the rigorous standards of the NFPA specification T2.6.1.
• All HyPerformance valves are tested at a verification level of 90% and an assurance of 99%.
Operating Pressure: 350 bar (5075 psi) 10% cycle life: 420 bar (6090 psi)
Cycle Life: One million cycles
Proof Pressure: 420 bar (6090 psi)
Burst Pressure: 1380 bar (20000 psi)
Flow: Up to 95 lpm (25 gpm)
Internal Leakage: 0.25 cc/minute (5 drops/minute) max. at 240 bar (3500 psi)
Temperature: -40° to 100°C (-40° to 212°F) with Buna N seals;
-26° to 204°C (-15° to 400°F) with Fluorocarbon seals;
-54° to 107°C (-65° to 225°F) with Urethane seals
Filtration: See page 9.010.1
Fluids: Mineral-based or synthetics with lubricating properties at viscosities of
7.4 to 420 cSt (50 to 2000 sus); See Temperature and Oil Viscosity, page 9.060.1
Installation: No restrictions; See page 9.020.1
Cavity: HVC12-2; See page 9.112.1_2w
Cavity Tool: HCT12-2xx; See page 8.600.1
Seal Kit: SK12-2U-0; See page 8.650.1
Cartridge: Weight: 0.18 kg. (0.40 lbs.);
Steel with hardened work surfaces.
Zinc-plated exposed surfaces; PPDI urethane seals without back-ups standard.
Standard Ported Body: Weight: 2.74 kg. (6.05 lbs.); H-series ductile iron standard. Rated to 345 bar (5000 psi).
See page 8.012.1_2w.
|Selection guide - similar valves.
||PDF file of this page.||Request a quote.|