- Services & Support
- Sales & Distribution
Directional Valves — HyPerformance™
HPC42-J49— Piloted Directional Element, Balanced Poppet, Normally Open
Selection guide - similar valves.|
PDF file of this page
Request a quote
A high pressure, two-way, bi-directional, pilot-to-open, balanced poppet-type, screw-in,
cartridge-style, hydraulic directional element designed to function as a load-holding or
blocking valve in applications requiring low internal leakage.
In the unpiloted state, the HPC42-J49 allows flow from 1 to 2 bi-directionally. On remote
pilot signal at port 4, the valve shifts to block flow from ports 1 to 2 bi-directionally. The
spring chamber is vented to port 3. Pressure at port 3 will directly affect the pilot pressure
required to shift the valve must be added. The hydraulically balanced poppet will allow
ports 1 and 2 to be fully pressurized without affecting required pilot pressure to actuate the
valve. With port 3 vented, the valve will fully shift with a minimum pilot pressure of 14 bar (200 psi).
• Bi-directional flow.
• Balanced poppet.
• Low internal leakage.
• All HyPerformance products are tested to the rigorous standards of the NFPA
• All HyPerformance valves are tested at a verification level of 90% and an
assurance of 99%.
Operating Pressure: 350 bar (5075 psi); 10% cycle life: 420 bar (6090 psi)
Note: All HyPerformance products are tested for 900K cycles at 350 bar and 100K
at 420 bar.
Proof Pressure: 690 bar (10000 psi)
Burst Pressure: 1380 bar (20000 psi)
Flow: 380 lpm (100 gpm)
Internal Leakage: 15 drops/min at 350 bar (5075 psi)
Temperature: -40 to 100° C (-40 to 212° F) with standard Buna seals;
-26 to 204° C (-15 to 400° F) with fluorocarbon seals;
-54 to 107° C (-65 to 225° F) with urethane seals
Filtration: See page 9.010.1
Fluids: Mineral-based or synthetics with lubricating properties at viscosities of
7.4 to 420 cSt (50 to 2000 sus); See Temperature and Oil Viscosity, page 9.060.1
Installation: No restrictions; See page 9.020.1
Cavity: HVC42-J4; See page 9.142.1_4w
Cavity Tool: HCT42-J4XX; See page page 8.600.1
Seal Kit: SK42-J4N-BTM (Buna N); SK42-J4V-BTM (fluorocarbon);
SK42-J4U-000 (urethane); See page 8.650.1
Cartridge: Weight: 1.5 kg (3.3 lb) Steel with hardened work surfaces. Zinc-nickel plated exposed surfaces. PPDI urethane seals without back-up rings standard. Buna N and fluorocarbon seals also available.
|Selection guide - similar valves.
||PDF file of this page.||Request a quote.|