Pressure Control Valves

HPB08-E40 — Pressure Reducing/Relieving Spool Valve, Pressure-Balancing
   Selection guide - similar valves.
   PDF file of this page.
   Request a quote.

HPB08-E40 Valve

SYMBOL:
HPB08-E40 Valve symbol

 

DESCRIPTION
A screw-in, cartridge-style, direct-acting, spool-type, hydraulic pressure load equalizer
valve, with internal spring pilot chamber drain and spool damping chamber. It is designed
to act as a pressure-balanced accumulator charging valve.

OPERATION
In its steady state, the HPB08-E40 blocks flow from port 2 to port 1 and port 2 to port 3.
Port 1 is control pressure. Port 2 is inlet. Port 3 is tank. Port 4 receives signal. Since port 1
and port 4 have a 1:1 ratio, signal at port 4 sets the pressure at port 1. The valve controls
the pressure on the accumulator by adding or removing oil.

FEATURES
• High pressure operation.
• Adjustments prohibit springs from going solid.
• Internal spring pilot chamber.
• Internal damping chamber. .
• Pressure-balanced accumulator charging.

RATINGS:
Pressure Rating: 350 bar (5,075 psi)

Proof Pressure: 517.1 bar (7,500 psi)
Burst Pressure: 1379 bar (20,000 psi)
Flow: 37.9 lpm (10 gpm) at maximum pressure
Maximum Internal Leakage to Port 3: 15 ml/minute (0.9 cu. in./minute)
Temperature: -40 to 100°C (-40 to 212°F) with Buna seals;
   -26 to 204°C (-15 to 400°F) with fluorocarbon seals
   -54 to 107°C (-65 to 225°F) with urethane seals.
   (Note: Urethane seals are recommended for operating pressures
   above 241 bar (3,500 psi).
Filtration: See page 9.010.1
Fluids: Mineral-based or synthetics with lubricating properties at viscosities of
   7.4 to 420 cSt (50 to 2000 sus); See Temperature and Oil Viscosity, page 9.060.1
Installation: No restrictions; See page 9.020.1
Cavity: HVC08-E4; See page 9.108_4w
Cavity Tool: See page 8.600.1
Seal Kit: SK08-E4X-BXX; See page 8.650.1



 

 

PERFORMANCE:

HPB08-E40 Relieving and Reducing Pressure

 

HPB08-E40 Inlet Pressure

DIMENSIONS:

HPB08-E40 Valve Dimensions

 

MATERIALS:

Cartridge: Weight: 0.17 kg (0.37 lb);
Steel with hardened work surfaces.
Zinc-plated exposed surfaces. Urethane seals recommended. aluminum knobs.

Standard Ported Body:
Ductile iron (code D) bodies are required
for operation over 207 bar (3000 psi).
Anodized high-strength aluminum alloy,
rated to 207 bar (3000 psi) also available, dimensions may differ; consult factory.
See page 8.008_4w.

 

ORDERING CHART:

HPB08-E40 Ordering Chart