A solenoid-operated, 2-way, normally closed, poppet-type, bi-directional blocking, pilot-operated, screw-in hydraulic cartridge valve with outlet flow check designed for low leakage in load-holding applications.
When de-energized, the SVCV08-20 blocks flow in both directions.
When energized the poppet opens to allow flow from 2 to 1, while continuing to block flow from 1 to 2.
The SVCV08-20 is designed to fit into the VC08-3 cavity with the normal inlet at cavity port 3 (valve port 2), the outlet at cavity port 1 (valve port 1), and cavity port 2 blocked. The pressure drop will be substantially higher if cavity port 2 is selected as an alternate outlet port.
Operation of Manual Override Option: To override, push button in, twist counterclockwise
180°, and release. In this position, the valve will remain open. To return to normal operation, push button in, twist clockwise 180°, and release. Override will be detented in this position.
• Continuous-duty rated coil.
• Hardened seat for long life and low leakage.
• Optional coil voltages and terminations.
• Cartridges are voltage interchangeable.
• Manual override option.
• Optional waterproof E-Coils rated up to IP69K.
• Industry common cavity – compact size.
Operating Pressure: 207 bar (3000 psi)
Flow: Up to 22.7 lpm (6 gpm)
Reverse Flow Check Valve Spring: 0.69 bar (10 psi)
Internal Leakage: 2 to 1: 5 drops/minute max. at 207 bar (3000 psi);
1 to 2: 10 drops/minute max. at 207 bar (3000 psi)
Temperature: -40° to 100°C (-40° to 212°F) with standard Buna seals;
-26° to 204°C (-15° to 400°F) with Fluorocarbon seals
Coil Duty Rating: Continuous from 85% to 115% of nominal voltage
Response Time: First indication of change of state with 100% voltage supplied
at 80% of nominal flow rating: Energized: 40 msec. De-energized: 46 msec.
Initial Coil Current Draw at 20°C: Standard Coil: 1.2 amps at 12 VDC;
0.13 amps at 115 VAC (full wave rectified).
E-Coil: 1.4 amps at 12 VDC; 0.7 amps at 24 VDC
Minimum Pull-in Voltage: 85% of nominal at 207 bar (3000 psi)
Filtration: See page 9.010.1
Fluids: Mineral-based or synthetics with lubricating properties at viscosities of
7.4 to 420 cSt (50 to 2000 sus); See Temperature and Oil Viscosity, page 9.060.1
Installation: No restrictions; See page 9.020.1
Cavity: VC08-3; See page 9.108.1_3w
Cavity Tool: CT08-3xx; See page 8.600.1
Seal Kit: SK08-3x-M; See page 8.650.1
Coil Nut: Part No. 7004400